masr0.5a~masr0.5m surface mount standard rectifiers features low profile space ideal for automated placement glass passivated chip junctions low forward voltage drop low leakage current high forward surge capability high temperature soldering 260 /10 seconds at terminals component in accordance to rohs 2002/95/1 and weee 2002/96/ec major ratings and characteristics mechanical date case: jedec msma molded plastic body over glass passivated chip terminals: solder plated, solderable per j-std-002b and jesd22-b102d i f(av) i r 0.5 a 5 a v rrm i fsm v f 50 v to 1000 v 15 a 1.1 v polarity: laser band denotes cathode end maximum ratings & thermal characteristics (t a = 25 c unless otherwise noted) note 1: mounted on p.c.b. with 0.2 x 0.2? (5.0 x 5.0mm) copper pad areas. electrical characteristics (t a = 25 c unless otherwise noted) note 2: pulse test:300 s pulse width,1% duty cycle. 10.0 --pf type max a - 0.93 1.10 v - items instantaneous forward voltage reverse current typical junction capacitance test conditions i f =0.5a (2) t a =25 t a =125 i r symbol min t j max. 150 c 5 100 600 800 1000 v 1000 v r =v dc 4.0 v ,1mhz operating junction and storage temperature range t j t stg ?55 to +150 c j unit v f - peak forward surge current 8.3 ms single half sine-wave superimposed on rated load i fsm 15 a thermal resistance from junction to lead (1) r jl 35 /w maximum average forward rectified current i f(av) 0.5 a 420 560 700 v maximum dc blocking voltage v dc 50 100 200 400 600 800 v maximum rms voltage v rms 35 70 140 280 masr 0.5j masr 0.5k masr 0.5m unit maximum repetitive peak reverse voltage v rrm 50 100 200 400 items symbol masr 0.5a masr 0.5b masr 0.5d masr 0.5g http://www.trr-jx.com
characteristic curves (t a =25 unless otherwise noted) http://www.trr-jx.com masr0.5a~masr0.5m surface mount standard rectifiers
package outline notice product is intended for use in general electronics applications. product should be worked less than the ratings; if exceeded, may cause permanent damage.or introduce latent failure mechanisms. the absolute maximum ratings are rated values and must not be exceeded during operation. the following are the general derating methods you design a circuit with a device. i f(av) : we recommend that the worst case current be no greater than 80% . i fsm : this rating specifies the non-repetitive peak current. this is only applied for an abnormal operation, which the general during the lifespan of the device. t j : derate this rating when using a device in order to ensure high reliability. we recommend that the device be used at a t j of below 125c. trr is registered trademark of rising-sun technology. rising-sun te chnology reserves the right to make changes to any product i n this specification to improve reli ability,functional characterist ics,or design without notice. rising-sun technology does not assure any liability arising out of the applic ations or any product descr ibed in this specificat ion. rising-sun technology advises customers to obtain the latest vers ion of the device information before placing orders to verify that the required information is current. http://www.trr-jx.com masr0.5a~masr0.5m surface mount standard rectifiers
|
